• Keil Phytec KC167 Serial Debug Problems
    I'm new to Keil and the Phytec boards, but am trying to debug serial comms through P2 (the one shared with CAN). I know there are conflicts due to interrupt sharing with the monitor, but is there a way...
  • Project Settings -> Phytec KC-161
    Hi. Where can I find the correct settings for aplications using Phytec KC-161 eval board? Because the arrays are not initialized when the device is running without debug. I'm a biginer and i tryed the...
  • Phytec LPC3250 linux ethernet problem
    Hi, I bought the Phytec LPC3250 board for linux. I used the prebuilt linux kernel and uboot images and embedded them to the board and it booted successfuly. However, the board could not get an IP...
  • Help creating .H86 file for Phytec KITCON-167
    Using DaVE 2.0 and uVision 2.02, I'm not having any problems getting small programs into a .H86 file to flash over onto the Phytec KITCON-167 board. The problem shows up in slightly more complex and...
  • LPC3180 phytec board
    Hello I am using LPC3180 PHYTEC board with uvision-3. uvision doesnt support the peripheral simulation of lpc3180 yet. Is it possible that i use eclipse for development and for debugging i use...