• Take Back Half Algorithm
    Dear All I am working on a project where i need to heat a small amount of water in brass tube to precise temperature(say 50 deg +/- 0.1deg). Coil is wound over the brass tube for heating purpose...
  • Half precision float
    Is there support for 16 bit half precision floating point in RV compiler? infocenter.arm.com/.../index.jsp Are there any examples/sources for conversion between single and half precision (I...
  • half-duplex TX not working
    Hi, I'm using the STR710fz2 processor, and two of the UART receive lines that can be configured as half-duplex UARTs. I intend to use this as a transmit UART. First, is there a way to configure...
  • configure PIO of ARM9 as input.
    hi all, I am Kirti Patel from india. i am using AT91RM9200+FPGA SBC board made by darell harmon... in this board when i read the status of the pio pins during execution ..at that time i am not getting...
  • AGSI port configuration as in input
    All, I'm trying to develop a custom DLL using uvioion AGSI interface. Most of the function are working fine exept the fact when I need to use port0 and input/output port. When i set the port for...