uVision Logic Analyzer GPIO in SW simulation?

Hello, I try use sw simulator for debbuging STM32F103C8 ( DARMSTM.DLL -pSTM32F103C8) and I would like to monitor the status GPIOC pin 7 in the Logic Analyzer. In Setup Logic Analyzer I add PORTC.7...
Newbie needs help on which libs to use with a stm32f103c6 microcontroller

Hi all, how are you?, Im very new with ARM microcontrollers and I've been doing a lite lecture of about 4 books to know how to configure this devices to start programming it, first I did a reading an...
I can't use '__HAL_RCC_GPIOx_CLK_ENABLE()'

Hi, i am new with Keil. I tried to blink a led. So, in order to enable clock I looked into "stm32f4xx.h" header file. And i see that this instruction below 'How to use this driver' (#) Enable the...
CMSIS driver callbacks don't support user data

I'm trying to write an object-based solution on top of the CMSIS Driver_I2C which would allow simultaneous handling of multiple I2C interfaces connected to devices of certain type. Things got complicated...
DON'T KNOW HOW TO RUN A PROGRAM

I'M USING PK51-EVAL. I COMPILED A PROGRAM BUT I DIDN'T KNOW HOW TO RUN IT. CAN YOU HELP ME? THANK A LOT