• problems with start/stop debug session
    Hi, I'm new to Keil but have been working with micros for many years. I am using Keil vision 2 and am programming a Cypress USB chip. The code compiles with no errors. I can download it from Cypress...
  • Shutting down debug session
    Hi, I genareted a basic test project with stm32MXcube. I2C is active only. But i can not debug this project. After remap command (__HAL_AFIO_REMAP_I2C1_ENABLE();) shutting down debug session. ...
  • Debug session ending unexpectedly
    I am programming a TM4C123GH6PM EVB for the Cortex-M4 using mVision5 and the Stellaris ICIDI debugger. The project builds without error and I can flash the project to the board but when I start a debug...
  • I2C session abruptly ends
    Hi! I'm working on LPC1857 controller and I required to test the i2c code I wrote. As far as I can see,as per data-sheet I've got all right with code. While the application is run, i2c is disabled...
  • Troubles with Debug Session
    Hello everyone. May be somebody know what is it when I enter in Debug session and press F10 or F11 command pointer (yellow triangle near line number) performs each comand (or "each line") several times...