• Runtime Configuration of MAC Address
    Hi, I'm using RL-NET 6.4, I wanted to change MAC address of my boards dynamically, there is this evidence in documentations. The MAC address is written to the Ethernet controller registers when...
  • Change load region at runtime
    Hi All, I am implementing a software upgrade mechanism (burning a new image into a flash memory area). The problem: I don't know how to change the load region address at runtime. Flash contains...
  • IP change at runtime
    In keil NETWORK stack, how to change IP address in runtime? In documents, LOCALM is given but there is no example to use it. Thanks
  • CMSIS ETH MAC+PHY DRIVER
    Hello my LPC board setup as an Ethernet transmitter is constantly sending out 0x55 (Ethernet preamble), I'm writing the frame to the transmit buffer using the in the CMSIS ethernet driver (see below...
  • CC1010 - Changing the frequency runtime
    Hi Guys, I am trying to find out if it is possible to change the receiver frequency [for CC1010] during runtime. For example, i start at 433 MHz, then, after a few seconds I will change the frequency...