• Burn hex file to MCU for production
    I have made code on LPC1317 & tested. Now on debugging axf file get accessed by keil. 1. Now I want to program large no MCU, will everytime I have to use debugger to write hex file which in tun...
  • Not able to burn the hex file into LPC2148
    Hello All, I am Amit. Trying to burn the hex file into LPC2148 by using flash magic 5.70.2079 But I am getting error, "Operation Failed. Failed to autobaud - step 1." I have tried a lot...
  • p89v51rd2 code simukation working but after burning not working
    I am using following program for P89v51rd2. In Keil simulation is working but when i am burning same using Flash Magic ,it is not working. I have checked Memory Data using Flash Magic It is same as in...
  • Code not burning..
    Hi, i have burned code in Teridian's 71M6541F IC which has 8051 15 core inside using Signum's ADM51 emulator. However, earlier code was working fine and I could see the output on LCD. I set one bit in...
  • DS89C450 code burning problem.
    Hello Everybody, I have a EPROM programmer at my college. I wanted to burn code in my DS89C450 uC. the programmer had only DS89C420. i checked the datasheet it says that the 2 IC's are pin compatible...