• Stucking at breakpoint
    Hi, sometimes the debugger stucks at a breakpoint and even if I use single-step, step-over or just run the program, the PC does not change. Deleting the breakpoint does not fix the problem. I have...
  • debugger stuck in start up file
    I am using Tive C series TMC123gh6pm ARM cortex controller.I use Keil v.5.27 debugger . I have written a program which sets two of the GPIO Pins. The program compiles with no errors. When I debug the...
  • LPC11C got stuck after NACK CAN msg
    I have two LPC11C14 connected via can bus, terminated by 120Ohm on both ends. I also connected Logic Analyzer to scan CAN bus. I was able to send one message over the bus, without acknowledging the message...
  • Stuck at Startup code
    Vectors LDR PC, Reset_Addr LDR PC, Undef_Addr LDR PC, SWI_Addr LDR PC, PAbt_Addr LDR PC, DAbt_Addr NOP ; Reserved Vector LDR PC, IRQ_Addr LDR PC, [PC, #-0x0120] ; Vector from VicVectAddr ...
  • armlink stuck in armcc
    Hi I want to use armcc to pre-process my scatter file: #! armcc -E ... but armlink gets stuck. If I kill armcc.exe armlink returns an error that armcc terminated (because of killing). Any idea?