• pll and clock setup issue on mcbstm32c
    hey,, >>i want to use usart-2 peripheral on MCBSTM32C and i realised the baud rate set was incorrect, (inspite of right calculations) which was because of the incorrect plck-1 (=112.5Mhz, which should...
  • PLL Configuration
    Hi We are using LPC2366 controller When we configure the Internal RC oscillator(4 MHZ) for the PLL as shown below Main OScillator = disabled PLL source = Internal RC oscillator(4 MHZ ) ...
  • PLL,UART
    I am new to keil,just give me some basic idea about initilizations involved.
  • problem in pll settings
    hello I am currently working on a project which has 20 Mhz osc. I am using LPC2368 I want CCLK should me 48Mhz Can anybody please explain me configuration required for pll registers. I have gone...
  • MCB2300 pll settings?
    Looking at lpc2300.s from the RTX_blinky for example, it looks like cclk would end up running at 24mhz. Am I interpreting this correctly, and if so, why is it set so slow? Dave