• Tiva TM4C123G UART transmission
    Hello everybody, I am currently programming a Tiva C series, TM4C123GH6PM Evaluation Board from TI. I need to send a relatively large amount of data to the virtual com of the PC. This board has an...
  • SPI to HDMi converter for tiva
    Hi, I want to know whether there is any support for a SPI to HDMI converter. I would like to know the feasibility of a SPI to HDMI converter if there are any, so that i can use SPI to send data and...
  • Tiva C, Matlab,
    Hi all, I have a Tiva-C board that I configure with Keil. I want to perform a simple task - when my MATLAB runs a specific command, I want to send an "On" trigger (analogoutput 3.3V) to a NI PCI...
  • tiva c series TM4C123GXL
    Hi. I'm trying to learn to use SSI. I have programmed SSI2 as master and working using loopback. I have set the interruption on rx. After I send the fourth 16bit word, the interruption is set but all...
  • Reset USB in TIVA
    hi all, I am using TM4c1237h controller, I have interface Keyboard and Pendrive to TIVA.I am using FSUSB11MTX for multiplexing them.Using a GPIO pin .Because of noise the controller of IBM controller...