• Application won't start
    Hi, I'm trying to port and older RTX project which uses external SDRAM. But before it gets to main() I'm getting an Undef_handler error. When I single step I find that the error occurs at a specific...
  • How to change the application start address?
    Hi, I'm using the STM32F103ZD uC and the Keil IDE uVision V4.03q. I would like to place my default application at the lowest flash address 0x0800 0000 and I like to place my bootloader at address...
  • MCBSTM32E board application does not start
    Hi, being new to ARM I succesfully builded and downloaded the Blinky project into the STM32F103ZE uC on the MCBSTM32E board. It did run, but somehow it does not anymore. The IDE says "Application...
  • IAP: Starting application code execution
    Yet another IAP question! I am writing an IAP (In Application Programming) tool where a dedicated update button is not available. I must code around the issues this presents. The processor will...
  • Application did not start at 0x10000 on C167
    hi, i hope i'm right here and someone can help me: I am using a C167CS with 2x 128k x8 flash (ST29F040BB) on the external 16 bit demultiplexed bus (with WRL&WRH). Flash is connected to CS0 (segment...