• MCBSTR9 demo using cross-over cable to laptop
    I tried setting up the MCBSTR9 board directly to laptop using a cross-over cable. I loaded a DHCP server on the laptop that someone recommended, and ran a network analyzer program to watch what happens...
  • TCP connection cable test
    Hi every one, I developed a embedded system with lpc17xx (Cortex m3) equipted with interface ic KS87Bl for Ethernet communication.there are two LEDs in RJ45 which indicate that the CAT5 cable is inserted...
  • Cable RS232
    Hi, I want to connect a "LPC1788 Developer’s Kit" board to my PC. I have RS232 port in both sides. Should i use straight and crossed RS232 cable ? thank you in advance.
  • Ethernet cable insertion detection
    Hello, I need to make sure that my LPC2478 will configure its DHCP only after the physical insertion of the Ethernet cable into the controller (it seems that TCPNet cannot handle a situation where...
  • network cable is disconnected for a moment
    why it can not access the destination Host when the network cable is disconnected for a moment and later this connected again? //----------------------------------------------------------------...