• AT91SAM7S256 and the RSTC register...
    Okay... admittedly this is slightly off topic, since I don't think it really has anything to do with the KEIL tools per se, but I am using KEIL tools on this project. I originally posted this on AT91...
  • SD Card resetting controller
    Hello, When I start up a circuit board with LPC2468 and SD connector (SD interface in 4-bit mode). without SD card present there is no problem. When I then insert a certain SD Card (2GB, SD Standard...
  • controller reset in uart communication
    Hello all, I am doing one project in microcontroller is LPC2378. I am doing serial communication of LPC2378 with PC, I am sending some packet to PC and software running on PC sends me acknowledge...
  • Can the controller be reseted using program?
    I am using a 89s8252 controller. I am wondering, is there any command u can call to reset the controller so that it will run from the start again? I know that using watch dog timer will reset the...
  • ULINK keeps controller in reset when not connected to PC
    Hi everybody, I have a custom pcb with a 20-pin standard Cortex-M debug connector. The schematic of the debug interface is equal to the one on page 26 in this document: www.mouser.com/.../Board_Users_Manual_CPU_Board_XMC4500_General_Purpo...