• A question about Cortex M0
    Hello, This is not a Keil specific question, but I was hoping that somebody would be able to clarify the following as I don't have a lot of experience with Cortex M0 chips (I have a LPC1114 at my...
  • About ARM Manual
    Sir, I am trying to stude ARM. While going through the manual, in tables i seen : PINSEL1PinNameFunction ..................... 1:0 P0.16 GPIO Port 0.16 EINT0 Match 0.2 (TIMER0) Capture 0.2 (TIMER0...
  • Doubts about RLT-ARM
    Hi, I receive a quotation about KEIL plus RLT-ARM with stack TCP-IP. In my application I'm using a ARM7 (from NXP) with Mac/Phy and a serial Interface (RS232) to connect with a GPRS modem. Using...
  • About Installing Keil for ARM
    Now, I have installed Keil C806 on my computer. And I want to install the Keil for ARM, do I need to uninstall the C806? If these two are on PC together, is there some impact between them? Can you tell...
  • ARM: about passing parameters.
    The following code is from a project compiled and run very well under Realview Debuger platform.But when transplanted to Keil uVision3, it can be successfully compiled and booted, but overflowed in many...