• uLink2 initialization file - map command?
    Hi I am using a cortex m3 arm from microsemi and I am trying to get the uLink2 debugger to load and debug my code. I have the standard on board 64K of nvm (addr 0) which is only good for start up...
  • at command
    /*My program was given below my concept is to connect the gas sensor to P3^7 pin of micro controller and alarm connected to P3^6 pin of micro controller. P3^6 is low means the alarm is on. When the gas...
  • mapping between hex and map
    Hi. I am developing a Nordic MCU nrf51822 using uvision5. Although the two development environment versions are slightly different, there are two different hex files after building the code (2charater...
  • memory mapping
    Hi, Maybe this is not the right forum for this question, but is there anyone who can tell me the correct settings to compile HID-firmware for the FX2? The problem is, I've written some firmware...
  • Memory Map
    uVision2 MENU: DEBUG/Memory Map I have to re-enter the memory map every time I go into debug with the below information. With Read and Write check boxes checked. X:0x100000,X:0x10FFFF X:0x180000...