• EPM900 Bootloader not running!
    Dear experts, I'm in trouble now. my Keil EPM900 has gone hail-wire I guess. The message that I get whenever I try to put it into debug mode, says ' EPM900 boot loader is not running'. Tried...
  • LPC900 Emulator Bootloader is not Running
    Hello all, I have the folowing problem. When starting debug mode in the uVision software the following error occurs: "LPC900 Emulator Bootloader is not Running!" On the Keil forum I found another...
  • EPM900 Bootloader not running
    Hi, I've been using an EPM900 board with an LPC936FA chip for the last few weeks, and when I tried switching to debugger in the EPM Emulator mode a few days ago, I got the message that the Bootloader...
  • Secondary UART bootloader example
    I'm looking for some example code to write a secondary UART based bootloader, my design has an external supervisor/watchdog IC on the board, this means that for the initial programming I need to disable...
  • Need example to get CAN running
    I have problems to get the CAN controller on my Infineon XC886 CM running. Have someone example code for sending a CAN message via CAN node 0 (CAN RXD Port 1_6, CAN TXD Port 1_7)? I have tryed to use...