• unable to connect altera USB blaster
    It shows "Unable to load driver 'd:\Keil\ARM\BIN\ABLSRCM.dll' with possible reasons as 1. Driver dll could not be found in the specified path 2. Driver dll requires additional dlls, whicha are not...
  • unable to connect to 89V51RD2
    hi, i have a question regarding programming the P89V51RD2 microcontroller. i am using Flash Magic SW to program my code. previously I have programmed a code which trasmits "AT" endlessly on the...
  • USB CDC on STM32L device : unable to connect to host.
    Hi all, I try to make a device based on STM32L151 which will communicate through USB in CDC mode. My software was initially developped on an STM32F4-discovery board, and it was working perfectly...
  • Unable to connect to the specified boud rate.
    I use a RS-232 cable and connect the PC com1 with MCB900 to programming the 89LPC21 but got error message as "Unable to connect to the specified boud rate. Try reducing the boud rate. Reset the hardware...
  • Unable To Connect Keil Monitor To Cypress EZ-USB FX Development Board
    I'm working with a Cypress EZ-USB FX Development Kit. Per the EZ-USB Contents and Tutorial manual, I'm trying to run the dev_io example program by loading it from the Keil debugger. After following the...