• cpu clock (cclk)?
    hi i am using lpc2364 processor. Clock is 14.7456mhz. I have set cclk to 70.77888mhz, hclk to 353.9844mhz using pll. In data sheet there is range for hclk (275mhz to 550mhz). My doubt is what is maximum...
  • What Is the real CCLK referenced ? (used for IAP and FlashFS)
    Hardware : MCB2300 Board (LPC2378) Xtal : 12Mhz I read on some post that the CCLK to set in the IAP code is 12000 (KHz) http://www.keil.com/forum/10740/ When I give a look at the LPC_IAP2_512...
  • Error simulating the LPC2378 uC
    Hello to all! I tried to debug the Blinky example shipped with the MCB2300 board in the Simulator mode. However, the code was blocked in a endless loop, waiting for the main oscilator stabilize. ...
  • Overrun Error in LPC2378 UART1
    I'm interfacing GPS module with LPC2378. The GPS module is sending data continuously and the packet size is more than 100 bytes. The receiver buffer's(RBR) size is 16 bytes. As soon as GPS module is...
  • LPC2378
    I have used LPC2378 on my board. when the LPC2378 is in Virgin state (fresh IC never had been programmed), and i connect the Ulink2 to target PCB. But JTAG doesnt recognize the target IC. when i flash...