• MSC1210
    HI, i hav written a piece of code tat executes continuously i.e. while(1) In this there r two condition statement: if(SBUF1==0x20||SBUF1==0x7F||SBUF1==0x0FF) { //Statements } else if(SBUF1==0x53...
  • MSC1210 problem
    I program the msc1210 with the keil but when i power on the device the program don't start run, only run after i press the reset button. Can anyone help me. Thanks
  • debug MSC1210
    Now,I'm using Keil software debug TI MSC1210. When I connect ISD51,the screen shows the following information: "Loaded application does not match the ROM content!Please program your application into...
  • HELP volts step down problem
    i m attaching a circuit diagram which is step down the 220V AC to 7-8 A DC (AC?) can anyone explain the working of the 1 M ohm resistance and 1uF capacitor ,how they work and step down the voltage...
  • MCB2300 3.3 and 5 volts on board
    Dear All, I see in bottom to the MCB2300 (LPCR2378) and between INT0 button and buzzer the exits for 3.3V, 5V and GND. I have measured these exits (3.3 + GND and 5 + GND) with test multimeter but...