• Code doesnt run after 'write flash' stm32f4
    I have a strange situation, code works fine in st link debugger mode. But when i press f8 which means write code to flash, and reset the device - seems like code not running. i use stm32f407 discovery...
  • MDK 5.33 MBED bulid failed, worked with 5.30
    Hi, my MbedOS Project did build with MDK 5.30, however with 5.33 the vrey same source does not build anymore. Same numbers of warnings, but an error saying multiply defined. What's also interesting, the...
  • AT91SAM7X128 don't run after reset
    Hello, I have a problem with SAM7X128, I've made a simple program and it works fine (blinks LEDs...) but only as long as I don't switch the power off. After I reset the MCU by power down, it does nothing...
  • Program written on Keil V 3.90 doesnt works
    Hi... I was using Keil Version 3.72.. but now upgraded to 3.90. The problem now i am facing is that, the program works well in debugger but when it is flashed on to microcontroller (LPC2129)...it doesnt...
  • After RESET
    In one of my projects where I use 89v51rd2 microcontroller, I connect one O/P pin to Electric AC bell through relay. My problem is when reset during switch ON, my O/P pin goes high and come down thus...