• CMSIS ETH MAC+PHY DRIVER
    Hello my LPC board setup as an Ethernet transmitter is constantly sending out 0x55 (Ethernet preamble), I'm writing the frame to the transmit buffer using the in the CMSIS ethernet driver (see below...
  • Problem with Debugging
    Hello. I am writing a simple program for the EZUSB FX2 board, when I compile, I have no errors and no warnings but when I try to debug (my interrupt function is not working) then I get the following...
  • Debug Problem
    I am usimg uVision3 V3.72 evaluation V. I am write moduler program for all peripheral in LPC2138, now i just integrate them together, BUT THE PROBLEM is when i start debug it goes into run mode, and...
  • debug Problem
    I want debug the example of EXTMEM on Keil MCB2300 Board,I get the following error: " Data Abort: ARM Instruction at 00000174H, Memory Access at FFE08000H" someone can tell me what is this error. ...
  • Debug problem
    Hi, I am working on a project which uses Cortex-M3 processor and STM32W108CB microcontroller and I use keil uvision4. The problem is the execution of the program stopped before it goes to the main...