• Could not stop ARM devices
    "Could not stop ARM devices,please check JTAG cables" will frequently occues, if you use keil Vision IDE, the follows are some common reasons that cause the error. 1. JTAG cables issue 2. JTAG speed...
  • Could not stop ARM device !
    In an effort to write a boot loader, I have changed the configuration so that the device starts executing code from bank 1. It doesn't work. ... Since then I am unable to access the flash device. ...
  • "could not stop ARM device"
    uVision 3... I try to stop the debugger to see why my application is crashing. But then I get "Could not stop ARM device! Please check the JTAG cable." I then have to cycle power to be able to run my...
  • could not stop arm device
    hi I have few problem with communicating with the ULINK debugger with the LPC2468 it keep on displaying the message "could not stop arm device" i selected the right device settings and tried,so please...
  • Could not stop ARM devices
    I have two same target boards with LPC2366 mcu, one of them has problem when i try to download hex file to flash via ulink. a pop-up window shows Could not stop ARM device! please check the JTAG...