• UART1
    Hi at All In LPC2364 the TX1 and RX1 pin on Uart1 are present in Port0 and Port2,is possible use both this pin for receive and transmit the data from two system? when device1 transmit/receive on Uart1...
  • LPC1758 CAN Controller
    Hello, EveryOne I'm newbie to CAN protocole and embedded software. I need some help with the famous protocol CAN. The MCU that I use is LPC1768 and I have an evaluation bord MCB1700. I need to...
  • LPC1758 ISP problems
    Hi, I am using the MCB1700 board and both Flash Magic and some software I wrote myself to try and get ISP programming working on COM0 Firstly, I am quite confused about jumpers. From reading...
  • How to configure the I2C on lpc1758?
    How to configure the I2C on lpc1758? I want to wirte a program on I2C master to control a srf08 sensor. Any example code to setup the I2C on lpc1758?
  • MCB1700 LPC1758 LCD
    I have an MCB1770 board on my desk with LPC1758. I am playing around with the Demo example from keil.com. Program compiled and flashed successfully. I expected to see LCD show up a graph but there was...