I have an AXI4 initiator that issues a 32-bit read request to an AXI target (memory) via a 64-bit wide data bus.

I set the ARSIZE parameter to 2.

The data in the target memory are the following:

addr   : data
0x000: 64'h 77_66_55_44_33_22_11_00
0x100:…

HI All,

I am trying to use FREE RTOS in cortex R5 dual core MCU.

Initially the MCU is in Supervisor mode. But in main function, i want to be a processor mode will be in system mode(0x1F).

But i do not find any instruction how to switch from supervisor…

Hello everyone!

I'm wondering if any Arm Mali GPUs, except for Mali-G78AE, are connected to a SMMU.
I have checked that Mali-G610 isn't connected to SMMU (at least in sysfs & device tree).

It's common to have peripherals isolated via SMMU or…

Following the getting started example here: https://learn.arm.com/learning-paths/microcontrollers/asm/setup/ I cannot get past the Configure the FVP section. The instruction to browse for the FVP provided with the MDK at Keil_v5/ARM/FVP/MPS2_Cortex-M…

ARM IHI 0033C:: Section 3.5.2 Write strobes rules: The first bullet point have 2 sub-points stated below:

The first one states that "Write strobes which correspond to an active byte lane can be HIGH or LOW. A transfer with LOW strobe bits for active…

Hello team,

I have a requirement which says "Periodic software readback of static configuration registers".  I'm using ARM R5F. Can you provide me a list of these registers and their addresses and contents?

Thanks and Regards,
Vishwanath Reddy…

This error occurred when I started debugging a simple program using MDK Lite Ver 5.38.0.0. From the error message two issues are apparent: The licence file is missing and the location of the licence file is expected to be under the C:\Program Files folder…

I wanted to confirm that the following is the latest version of the ARM trusted board boot requirements (TBBR) - https://developer.arm.com/documentation/den0006/latest/

The document from the above link is noted as being a Beta rather than a final release…