Hi,

I am just performing the first steps with the DesignStart Eval Edition (Cortex-M0), trying to compile the verilog sources to get a simulation running.

So I changed /systems/fpga_testbench/trl_sim/makefile to use gcc and modelsim and now I want to …

Hi,

I am working on a GPIO IP for Designstart Pro Cortex-M0. Now in my Simulation there are some Read-Modify-Write cycles in order to set only single bits in a 32 bit register.

If the GPIO register is 0x0000000X and I just want to set bit 16, GCC produces…

Hi,

     I am using Cortex-M0 DesignStart Pro. When I simulation intrrupt_demo test case, I found that IRQ[31:0]  always 0, Is this correct?

     I saw the document , the interrupt_demo is Demonstration of interrupt features, but if no interrupt signal input…