Hello,
I was able to find the information regarding TEE GlobalPlatform certification.
However, I was not able to find if it is required to path the certification for Trusted Applets (TA) development.
The only type of the information which I was able to…
From op-tee.org:
"OP-TEE is an open source project which contains a full implementation to make up a complete Trusted Execution Environment. The project has roots in a proprietary solution, initially created by ST-Ericsson and then owned and maintained…
These instructions demonstrate how to run an OP-TEE "Hello, world!" Trusted Application (TA) on Juno.
`ack-armlt' kernel:
+-------------+----------------------------+
| Workspace…非常急切地想问一下，在ArmV8这样的多核环境下，TEE如何对多个核进行安全环境的保护，采用什么样的机制？
我现在猜测，可能是其中一个核心A专门运行TEE OS（或者一个足够可信的OS），同时在TEE OS上面运行TA，用来处理一些指纹识别、可信支付这样的业务。也就是说这个核心就是Secure World。当然，这个核心，也可以作为一个普通的核心，来运行Normal World。
而在其他核心上运行Linux或者其他宏内核，或者一些不够可信的嵌入式OS，上面运行一些应用，也就是说这些个核心都是Normal…
Hello,
I have an ARM JUNO card and i want to install OP-TEE on it.
I'm using the Linaro last deliverable to boot up. Then i installed a Debian on it. However the packages like libc6:i386 are not available on it which make the setup impossible.
Can…
I'm using Linaro Release 15.12 LSK (without OP-TEE) + OpenEmbedded Minimal Filesystem on Juno-r1 Board.
I'm trying to put the Juno board into the Sleep-state referring to ARM Versatile Express Juno r1 Development Platform Technical Reference Manual…
Hi experts,
Today I was trying to use the latest OPTEE version to replace my previous one (v1.1.0) on my Juno board and I met one issue about tee-supplicant.
I used the initialization script from ashwildingarm 's post with the choice "Juno, latest,…
Hi Ash Wilding,
I'm currently using a Juno r1 board and I'm running the Linaro's deliverables on my board.
Recently I want to build the OpenEmbedded system by myself so I checked the instruction.
However, after I finished the first five s…
Hi experts,
I once bookmarked a weblink https://community.arm.com/docs/DOC-10804 which is showing how to set up a workspace for Juno board with OP-TEE 16.02.
Now I want to find a way to set up a new workspace with OP-TEE 16.02 while the URL is automatically…
Hi there,
After setting up the board followed by the instruction, I connect both UART ports with my computer. For my board one port shows normal world output while other one shows OP-TEE output.
In this case, I'm wondering is there anyway for me to print…
