Hi everyone,

I'm using Windows 10 operating system(i couldn't know if this is relevant to second part of my problem) and I want to embed Cortex M0 Designstart Design Kit on a Xilinx FPGA board. I'm currently trying to synthesize (AT510) r1p0-00rel0…

Hello, I started to tinker with the most basic Cortex-M0 from the DesignStart.
I am using Modelsim Student Edition, which run only on Windows (or Linux through Wine).

I tried to start with Linux to see if at least the "make" commands are working. Problem…

Hi,

I am just performing the first steps with the DesignStart Eval Edition (Cortex-M0), trying to compile the verilog sources to get a simulation running.

So I changed /systems/fpga_testbench/trl_sim/makefile to use gcc and modelsim and now I want to …

Dear all

I encounter a confusion that  I compile a piece a c code and generate HEX file( as instruction rom's initialization file) which is download to the fpga whit the cortex m3 prototype of Verilog code .but the M3 system can't run itself .when I…

Hi,

I want to simulate CM3 Designstart with Modelsim.

When I launch Modelsim from Quartus 17.2 most of the files compile. But I get the following error:

** Error: C:/projects/AT421-MN-80001-r0p0-02rel0/smm/logical/smm_common_fpga/verilog/fpga_pll_speed…

Hello together, I am little bit confused regarding to the Cortex-M0DS comparability to Altera FPGAs.

On one hand, according to the information out of the white paper An introduction to ARM Cortex-M0 Design Start it must be possible to run the Cortex-M0…