This question was raised in the ‘Want to maximise your product design? See how a custom ASIC can help?' webinar, view all the questions in the round-up blog post.

This question was raised in the ‘Want to maximise your product design? See how a custom ASIC can help?' webinar, view all the questions in the round-up blog post.

This question was raised in the webinar "Enhance your product with industry-leading processors - for no upfront license fee.”

This question was raised in the webinar "Enhance your product with industry-leading processors - for no upfront license fee.”

Hi everyone,

I'm using Windows 10 operating system(i couldn't know if this is relevant to second part of my problem) and I want to embed Cortex M0 Designstart Design Kit on a Xilinx FPGA board. I'm currently trying to synthesize (AT510) r1p0-00rel0…

All,

I received the Versatile Express Cortex-M Prototyping System + and am using DesignStart. I powered on the board and the operating system booted up without any problems.

In the V2M_MPS2/MB/HBI0263C/board.txt file, the following are the sequence of…

Hello, I started to tinker with the most basic Cortex-M0 from the DesignStart.
I am using Modelsim Student Edition, which run only on Windows (or Linux through Wine).

I tried to start with Linux to see if at least the "make" commands are working. Problem…

Hi,

I am just performing the first steps with the DesignStart Eval Edition (Cortex-M0), trying to compile the verilog sources to get a simulation running.

So I changed /systems/fpga_testbench/trl_sim/makefile to use gcc and modelsim and now I want to …

Hi

I have download the Cortex-M0 DesignStart Eval file (AT510-MN-80001-r2p0-00rel0),
and read the ARM FPGA board (MPS2+) datasheet.

The MPS2+ have many peripheral devices but we don't need it,
so we want made a platform for our use.

The user guide…

Hi,

I am using Cortex-M0 DesignStart Pro. I want to port the Model to FPGA, where I do not need any clock gating or power management. Is there a way to remove the PMU completely?

Best regards,
LeChuck

We are using Cortex-M0 DesignStart Pro to design MCU. When we use SWD to download grogram to flash in FPGA(Cortex_m0 mcu inside),  we cannot to connect keil with FPGA, and Keil shows:" Could not stop Cortex-M device!Please check the JTAG cable. "…

Hi,

I am using the SoC design from Desgn Start - Eval version for Cortex-M0 with only modification of using Xilinx Block ROM as the Memory for FLASH ROM as well as for RAM.

And my goal is to load the application into the FLASH ROM (Xilinx Block ROM) using…

Hello together, I am little bit confused regarding to the Cortex-M0DS comparability to Altera FPGAs.

On one hand, according to the information out of the white paper An introduction to ARM Cortex-M0 Design Start it must be possible to run the Cortex-M0…