The FPGA prescaler register address is incorrectly defined in the header file SMM_MPS2.h
This file is used in all Arm test software for MPS2, such as selftest, shieldtest, demo etc. The same header file is also used in MBED base code for MPS2.
The incorrect…
Hi,
I'm trying to build the MPS2 FPGA project (unmodified, as it is supplied in the kit) and constantly getting an error message saying "Quartus Prime Software quit unexpectedly".
It always crashes at the "Partition Merge" stage after…
Hi,
After compiling the MPS2+ FPGA designstart project (unmodified, as-is out of the box), i'm failing to run it on the FPGA.
While the already downloaded image that arrives on the FPGA runs fine (i run the demo application), the image I compiled…
Is it possible to directly program the FPGA in the MPS2+ board with the Altera Quartus Programmer?
As far as I understand is the MPS2+ 10 Pin FJTAG port not compatible to the Alter USB blaster.
Is there another way to do this?
Hello,
I want to use an USB Blaster cable for rapid FPGA prototyping on the MPS2+.
The cables differ very much in price. Is it recommended to buy an original Altera for over 200 Euro or can I use a cheaper nonamee one?
Could you please recommend a cable…
Hello expert:
In MSP2+ board, I found a micro USB connector and some ARM debugger connectors. Can I configure FPGA and run DS-5 using the same micro USB?
Thanks
Jimmy
I am currently in Evaluation phase of ARM Design Kits.
I am using the exact steps present in arm_cortex_m3_designstart_eval_rtl_and_fpga_quick_start_guide to compile the RTL and run the tests.
But, unfortunately after compiling the RTL I am getting a stack…
I am currently in Evaluation phase of ARM Design Kits.
I am using the exact steps present in arm_cortex_m3_designstart_eval_rtl_and_fpga_quick_start_guide_100895_0000_00_en.pdf
to compile the RTL and run the tests.
But, unfortunately after compiling the…
Hello,
I'm trying to connect the DesignStart Eval System to the BME280 Environmental Sensor via SPI. I used the SPI Shield0 Pins (EXP[11 to 14]) to set the connection and activated alternate functions in uVision for these pins. But how can I set up the…
If you are a microcontroller / SoC / ASIC designer working on Cortex-M processor based systems looking for an FPGA board for prototyping, I have a great news for you: ARM has released a new FPGA board called the Cortex-M Prototyping System.
Older versions of Cortex-M0 DesignStart required obtaining an Intel® Altera® Quartus Prime partial reconfiguration license. However this is no longer necessary with the latest DesignStart packages. See below for further information.
We started working on a daughter card we want to connect via the expansion ports, and we trying to understand the 52 IOs of the two expansion ports frequency capabilities (Board aspect) , is there any information regarding it ?
Are there any schematics…
