Hi,

I am just performing the first steps with the DesignStart Eval Edition (Cortex-M0), trying to compile the verilog sources to get a simulation running.

So I changed /systems/fpga_testbench/trl_sim/makefile to use gcc and modelsim and now I want to …

Hi,

I am working on a GPIO IP for Designstart Pro Cortex-M0. Now in my Simulation there are some Read-Modify-Write cycles in order to set only single bits in a 32 bit register.

If the GPIO register is 0x0000000X and I just want to set bit 16, GCC produces…

Hi,

     I am using Cortex-M0 DesignStart Pro. When I simulation intrrupt_demo test case, I found that IRQ[31:0]  always 0, Is this correct?

     I saw the document , the interrupt_demo is Demonstration of interrupt features, but if no interrupt signal input…

Dear All,

Currently I'm looking for information such as the below detail GPIO register from arm's design start kit.

The below image is came from STM32 which was called as RM0008.

I think arm design kit has also this information to control the…