Hello,
We bought ARM CM0+ deliverables from ARM. I want to design an SoC which has to get data from an another system .The aim of the SoC is to process an array of 4096 samples received from the external world.For the data interfacing, we are using GPIO…
Hi,
I am just performing the first steps with the DesignStart Eval Edition (Cortex-M0), trying to compile the verilog sources to get a simulation running.
So I changed /systems/fpga_testbench/trl_sim/makefile to use gcc and modelsim and now I want to …
Hi,
I am working on a GPIO IP for Designstart Pro Cortex-M0. Now in my Simulation there are some Read-Modify-Write cycles in order to set only single bits in a 32 bit register.
If the GPIO register is 0x0000000X and I just want to set bit 16, GCC produces…
Hi,
I am using Cortex-M0 DesignStart Pro. When I simulation intrrupt_demo test case, I found that IRQ[31:0] always 0, Is this correct?
I saw the document , the interrupt_demo is Demonstration of interrupt features, but if no interrupt signal input…
Cannot configure interupts of TIM6 on stm32f103 board
Does my NVIC configuration wrong?
Code:
@ stm32f103 timer & interrupt test by laper_s (from 2019-02-02) .thumb .cpu cortex-m3 .syntax unified .word 0x20005000 .word start + 1 b start…
Hi guy,
I'm using ARM STM32F103RC, Cortex M3.
when I compiler the code with this order:
//GPIO structure used to initialize port
GPIO_InitTypeDef GPIO_InitStructure;
//Enable clock on APB2 pripheral bus where button…
