Wenkwei asked: "with the M3 designstart CMSDK, is it possible to design multi-master bus? In the IoT Cortex-M TRM, only an ahb-lite structure is illustrated. That document does mention AHB and APB expansion through INTEXP[1:0] but what if there are more…

Hi,

I am just performing the first steps with the DesignStart Eval Edition (Cortex-M0), trying to compile the verilog sources to get a simulation running.

So I changed /systems/fpga_testbench/trl_sim/makefile to use gcc and modelsim and now I want to …

Hello everyone

I have Cortex-M3 Design evaluate and bought the V2M-MPS2 + motherboards.

But I do not know where to start to work on a model from the Quartus programmer

You can support me where to start the designs

Thank you

Hi,

II refer to the example MCU system level in the document "arm_cortex_m0_designstart_eval_user_guide", put it into MPS2+ after synthesis, the software uses the following example in this directory.

D:\CMPS3\AT510-MN-80001-r2p0-00rel0\systems…

I use the ARM Cortex-M3 DesignStart Eval on the FPGA platform, I use J-link to download the program to the system but the system is not properly implemented. I downloaded the generated Hex file via J-link to the FPGA development board via Keil. Is the…

Hi.

TESTNAME=bootloader test sequence is in  BP210 CM3 test sequence,

In especially, we could find the below code,

then we got the below error message when we ran the simulation.

23490 ns UART: CMSDK Boot Loader 
27270 ns UART: - load flash 
45710…

Cannot configure interupts of TIM6 on stm32f103 board

Does my NVIC configuration wrong?

Code:

@ stm32f103 timer & interrupt test by laper_s (from 2019-02-02)

.thumb
.cpu cortex-m3
.syntax unified

.word   0x20005000
.word   start + 1

b   start…