Hello,

I am using an Atmel SAMD21 MCU that is based off the ARM Cortex M0+. I am programming it via the Arduino IDE. I notice that the Arduino IDE includes the CMSIS library. Below is an example call from the library to setup a generic clock that compiles…

Hello,

DSP concept guys say, that it's time to use ARM Cortex-M microcontrollers for embedded DSP systems, so I looked at CMSIS library of filtering functions, and found that it is of block type.

As you know, the most painful feature of ARM Cortex-M…

Hi Experts,

Does the stack memory protection or some other similar feature is deployed in the CMSIS RTX RTOS ?

Regards,

Teachguyz

CMSIS DSP is a great tool which allows Cortex-M4 devices to have a great app field range, even replacing some general purpose DSP sometimes. However I am missing some "simple" new functions that could enhance, even more, the use of it.

For example…

Hi Experts,

I would like to remove and customize CMSIS RTX for the Cortex-M series micro-controllers to save some code space and may be possible optimization for hobby stuffs. For illustration, removing an RTX OS feature which I am not going to use. In…

Hi Experts,

I went through the CMSIS RTX code for Cortex-M and bit curious on the features & configurations.

In that I could see osFeature_MainThread  macro is defined for the requirement of main thread feature.

What is the practical use case (merits…

Hi Experts,

I went through the code  flow of CMSIS RTX RTOS. I am excited to know the real engineering done on building the RTX RTOS towards Cortex Microcontroller series. It can be some parameters like task switch time, interrupts latency time, etc. Any…

Hi Experts,

What is the special feature in the CMSIS ARM RTX RTOS compared to other commercial RTOS which makes the integration smoother and gives best performance ?

Hi

I am unable to find any documentation on how to add library in eclipse based IDE. Presently I am using Freescale's CodeWarrior and I want to add the CMSIS's DSP Library in that.  Thanks in advance

Kind Regards

Amit Kumar

Hi,

I am currently trying to use the CMSIS DSP library for finding the frequency bin. I have used both  CFFT and RFFT function to compute the frequency bin of input signal.

My input data is of 128 samples which content only real part (complex part…

On ARM official website, I saw some description about debug method by Freescale Vybrid.

It sounds like below (No JTAG or SW connection):

  [PC Host]  <--- USB wire ---> [Freescale Vybrid]

So it seems there is a bridge inside Vybrid, which…

Dear All,

Can I have the step by step, how to create a ( CMSIS library ) project using uVision 4 Keil IDE
My Project board is STM32F407 vg discovery board

Actually I need following  instructions acceptable project

GPIO_InitTypeDef GPIO_InitStruct;

Please…

I'm currently trialing the Keil uVision compiler V5 with the ST demo board MCBSTM32 (uses an STM32F103R8).

The Keil IDE indicates that a set of the inline assembler definitions are incorrect.

__ASM uint32_t __get_PSP(void)

__ASM void __set_PSP(uint32_t…

I tried to use FFT functions in a project and included the header file required for CMSIS library, arm_math.h.

But I found one issue.

Including “arm_math.h” in a project disables systick function which is used as timer event implementing source for the…

Hello,

I recently installed Keil MicroVision 5.0 and started working with an STM32 MCU.

I was impressed by the highly standardized environment that lets you use peripheral in minutes. However I understand that this environment is quite preliminary, at least…