Hi,

Can any one explain me how address decoding is done in amba ahb?

HRESP  is given  for address or data??

hi,

Is HREADY is used by the slave  to notify the master that it is ready to receive or to indicate transfer is completed??

thanks in advance

Hi,

In my design I am having a scenario where my Hsel goes low during the data phase of a transfer and Hready goes high one cycle after that? (i.e hready high during address phase low during data phase and high again in the follwoing cycle 1->0 -> 1)…

Hi All ,

                      The following figure shows the INCR4 burst transaction.

Here the address increment is happening in each clk cycle  As per AHB protocol Single outstanding address is allowed.

What are the possible adjustment has to be made for this transaction…

Hi,

 I am developing a RTL code for AHB lite - AXI bridge. I want to understand what are the possible error scenarios in AHB?

1.I can think of invalid address as the only case. Is there any other scenario?

2. I am performing a INCR4 transfer on AHB side…

Hello All,

  I have a 64 bit data bus and I am making a 32 bit INCR with length 4(INCR4) write on it by giving the starting address.

When  I read back at the same address, I am getting as 2 64 bit data each for 2 clock cycles. Why is this?

Scenario : Single…

Hello I want to know the calculation for

HSIZE=2 and Wrap 8

and starting address is 0x4

and how we are doing alignment ???

Hii,

Greetings !!

I would like to know the standard operating clock frequency and data rate of AMBA- apb, ahb, axi.

Please someone help me out.

Thanks in advance

Regards

Ujjwal