XC164CM program cannot run under debug mode of uVision3

Hello, I'm using uVision3 and ULINK to develop programs for XC164CM. While compiling a program there is a warning: *** WARNING L5: SECTION LOCATED OUTSIDE CLASS AREA SECTION: ?ND0?DLLMAIN...
XC164CM program cannot run under debug mode of uVision3

Hello, I'm using uVision3 and ULINK to develop programs for XC164CM. While compiling a program there is a warning: *** WARNING L5: SECTION LOCATED OUTSIDE CLASS AREA SECTION: ?ND0?DLLMAIN...
NXP LPC18xx sleep mode

Hi guys! I'm looking for an example how to disable the power of all peripherals of LPC1833 (except both CAN controllers) before putting MCU into sleep mode. According to NXP's data sheet the power consumption...
NXP LPC18xx sleep mode

Hi guys! I'm looking for an example how to disable the power of all peripherals of LPC1833 (except both CAN controllers) before putting MCU into sleep mode. According to NXP's data sheet the power consumption...
Non allocatable reset of NXP LPC2368 using RTX when modifiing variables

Hello everyone, today I'm asking for hints on a tricky problem. We have a firmware that uses RTX-Kernel running on a NXP LPC2368. Now the device that the firmware is written for should get a new...