ERRORLEVEL from command-line invocation of uVision2

I am integrating our builds into the Ant and CruiseControl architecture, but have run into a problem: when invoking uVision2 from the command line, e.g.: uv2 -b washer.uv2 uVision2 never sets ERRORLEVEL...
ERRORLEVEL from command-line invocation of uVision2

I am integrating our builds into the Ant and CruiseControl architecture, but have run into a problem: when invoking uVision2 from the command line, e.g.: uv2 -b washer.uv2 uVision2 never sets ERRORLEVEL...
Convert uVision2 project to a command line compile

Is there any way to convert a uVision2 project into a command line compile? Thanks for any info!
Convert uVision2 project to a command line compile

Is there any way to convert a uVision2 project into a command line compile? Thanks for any info!
flash magic error

i am trying to perform stepper motor interfacing with 8051 micro-controller.micro controller board-DYNA-51EB..Hex file is created in keil software.but using flash magic it is not able to transfer hex...