LPC2294 - NOT ENTERING IN MAIN

HI I AM FACING ONE PROBLEM IN LPC2294 CUSTOM BOARD. I CAN ABLE TO ERASE AND PROGRAM THE DEVICE. BUT IF I TRY TO DEBUG, SOFTWARE CONTROL IS NOT ENTERING IN MAIN FUNCTION. (24 MHZ CRYSTAL, PLL IS DISABLED...
LPC2294 - NOT ENTERING IN MAIN

HI I AM FACING ONE PROBLEM IN LPC2294 CUSTOM BOARD. I CAN ABLE TO ERASE AND PROGRAM THE DEVICE. BUT IF I TRY TO DEBUG, SOFTWARE CONTROL IS NOT ENTERING IN MAIN FUNCTION. (24 MHZ CRYSTAL, PLL IS DISABLED...
Does Not enter main while debugging

Hi All, I am using STM32 ARM cortex controller.I use UIlink debugger I am new to controller programming. I have written a program which sets one of the GPIO Pin. The program compiles with no errors...
Does Not enter main while debugging

Hi All, I am using STM32 ARM cortex controller.I use UIlink debugger I am new to controller programming. I have written a program which sets one of the GPIO Pin. The program compiles with no errors...
in debug mode, won't enter main()

Hello, I am looking for some help with my Keil uVision 5.27. I am able to run some example code for my chip that I downloaded from NXP. I have 0 errors and 0 warnings. I am able to go into the debug...