Set "Use Simulator" and "Run to main()" in Debug but does not stop at main()

I am using uVision V5.15.0 and built an generic M4 based project with "Hello World" program. Set "Use Simulator" and "Run to main()" in Debug tab, built code and started Debug Session, but debugger does...
Set "Use Simulator" and "Run to main()" in Debug but does not stop at main()

I am using uVision V5.15.0 and built an generic M4 based project with "Hello World" program. Set "Use Simulator" and "Run to main()" in Debug tab, built code and started Debug Session, but debugger does...
in debug mode, won't enter main()

Hello, I am looking for some help with my Keil uVision 5.27. I am able to run some example code for my chip that I downloaded from NXP. I have 0 errors and 0 warnings. I am able to go into the debug...
in debug mode, won't enter main()

Hello, I am looking for some help with my Keil uVision 5.27. I am able to run some example code for my chip that I downloaded from NXP. I have 0 errors and 0 warnings. I am able to go into the debug...
Code is getting executed before 'Run' in the debug mode

Hi, I am working with ARM cortex M4 on Keil MDK. 1) As soon as I start debug session, the code is getting executed before I run by pressing F5. 2) Also, the program is kind of halted at while loop...