How can I write STR912 flash in my capplication?

There is a example application in Keil folder, but it can only write and read flash by loading image into RAM, when I load image into Flash bank 0, it can't write flash! Would you please send a examlpe...
How can I write STR912 flash in my capplication?

There is a example application in Keil folder, but it can only write and read flash by loading image into RAM, when I load image into Flash bank 0, it can't write flash! Would you please send a examlpe...
Cant write port output with str912 demo board

Hi, I am new to ARM (usually work with 8051), and am working on a little RS232 GPIO board. Project is a serial input on port 3 (uart 1) takes 3 bytes in and writes the values to ports 0-2, and 4-9. ...
Cant write port output with str912 demo board

Hi, I am new to ARM (usually work with 8051), and am working on a little RS232 GPIO board. Project is a serial input on port 3 (uart 1) takes 3 bytes in and writes the values to ports 0-2, and 4-9. ...
STR912. Executing from bank1

We use Keil uVision V3.50 (MDK 3.04) and ULINK device; development board MCBSTR9 vers.2 with STR912 MCU. As the new version of MDK has a new feature for ULINK to program additional flash areas (UP...