LPC2378 - Unable to set FAST GPIO

Hi, I am new to uVision community. I have installed the latest MDK5.21a along with legacy support. While working on a simple project of toggling GPIO pins with LPC2378, I am unable to change the...
LPC2378 - Unable to set FAST GPIO

Hi, I am new to uVision community. I have installed the latest MDK5.21a along with legacy support. While working on a simple project of toggling GPIO pins with LPC2378, I am unable to change the...
FAST GPIO

hi, i am using lpc2378 ...when i configure port 0 and 1 as fast GPIO my uart baud rate becomes half...since i have used port0 and 1 to interface a lot of other peripherals i am not in a position to make...
FAST GPIO

hi, i am using lpc2378 ...when i configure port 0 and 1 as fast GPIO my uart baud rate becomes half...since i have used port0 and 1 to interface a lot of other peripherals i am not in a position to make...
Query Related to Fast GPIO

Dear all, In my development I am using LPC 2368 chip. In my project I used 2 PCB hardware . In 1st PCB I put down LPC2368 chip. And 2nd pcb I put down Ethernet Driver IC(DP83848C) , Ethernet and...