Problems with CAN Message Object 15 as general receive object

Hello! I'm writing software for test equipment and have to handle a lot of different CAN messages. (Controller: Infineon C167CR, Phytec Board, uVision 2) So I used the message objects 1 - 14 for...
Problems with CAN Message Object 15 as general receive object

Hello! I'm writing software for test equipment and have to handle a lot of different CAN messages. (Controller: Infineon C167CR, Phytec Board, uVision 2) So I used the message objects 1 - 14 for...
Register Settings to Use CAN Message Object 15 as receiver

I am pretty familiar with CAN message objects 1-14, but for some reason, my current register settings do not allow message 15 to interrupt on every message. Here are my settings: C1GMS = 0xE0FF; C1UGML...
Register Settings to Use CAN Message Object 15 as receiver

I am pretty familiar with CAN message objects 1-14, but for some reason, my current register settings do not allow message 15 to interrupt on every message. Here are my settings: C1GMS = 0xE0FF; C1UGML...
Viewing CAN registers/message objects on SiLabs 'F04x

I am using uVision with SiLabs 'F04x family of processors; trying to get the CAN engine to talk. Running the debugger; under 'Peripherals/CAN' drop-down menu, I can bring up a dialog box called "CAN...