Problem with EPM900

I am using EPM900 to debug a board with lpc932. I have to make a net RS485 multiprocessor with uart in mode 3, 9 bit . The problem is the seguent: if I run the firmware on the lpc932, the system work...
Problem with EPM900

I am using EPM900 to debug a board with lpc932. I have to make a net RS485 multiprocessor with uart in mode 3, 9 bit . The problem is the seguent: if I run the firmware on the lpc932, the system work...
Problem with LPC938 ADC with EPM900

Hi. I'm trying to simulate 89LPC938's ADC with EPM900, but somehow it is not working. The code runs, but the ADC doesn't run at all. Some info below: 1. Single channel using channel 7 at Pin 2.0...
Problem with LPC938 ADC with EPM900

Hi. I'm trying to simulate 89LPC938's ADC with EPM900, but somehow it is not working. The code runs, but the ADC doesn't run at all. Some info below: 1. Single channel using channel 7 at Pin 2.0...
Problem of EPM900： Can't enter Debug mode...

Help~~ I use EPM900 as emulator. When I entered Debug mode in uVision,the error message "CRC check failed on Command 'DownloadMonitor()'!" displayed and debug mode terminated. What happened ???