Debug Issue on embedded Cortex-M3 of SmartFusion2 : No source available for "0x0"

Hello, I am currently developing an FPGA architecture on Smartfusion2, where the cortex-m3 should control and update the different FPGA cores' registers. I exported the firmware using Libero SoC and...
build my own board ?

Hello, I want to build a ( SMALL & NARROW FOOTPRINT ) board that does audio DSP , so far, I tried : - using a teensy 3.6, but it has a terrible ADC (50% SNR) and the I2S interface is glitchy at best...
build my own board ?

Hello, I want to build a ( SMALL & NARROW FOOTPRINT ) board that does audio DSP , so far, I tried : - using a teensy 3.6, but it has a terrible ADC (50% SNR) and the I2S interface is glitchy at best...
Problem to configure Monitor for C166

I have app. board with C166 and 128k RAM only connected to C166 by 8b demux bus. I try to configure monitor in Bootstarp mode. When monitor code starts from 0h then there is no problem. Trying to place...
Problem to configure Monitor for C166

I have app. board with C166 and 128k RAM only connected to C166 by 8b demux bus. I try to configure monitor in Bootstarp mode. When monitor code starts from 0h then there is no problem. Trying to place...