• Internal Command Error
    Hi, I am working with stm32f303k8t6 and I programming stm32 with st link v2 mini. First I used this programmer normally but last week it was fail. And I bought a new st-link v2 mini. Now I try to...
  • internal command error
    hi I am working with nordic nrf52810 soc, when i flash code using stlink v2 i am getting "Internal command error", all my connections are correct. i can see my stlink connected inside debug in keil...
  • internal command error
    Hi when trying to download flash to STM32L152 using Keil and ST-Link V2 debugger from SW port, I see "Internal command Error" boot and reset dose not help. is there any way to get rid of this problem...
  • internal command error
    I was using uV4.2.1 for the STM32L-Discovery. After I changed the MSI frequency to range 0 (65,536 kHz) and debugged, the program ran slowly as expected on the board. However, whenever I clicked debug...
  • internal command error
    I was using uV4.2.1 for the STM32L-Discovery. After I changed the MSI frequency to range 0 (65,536 kHz) and debugged, the program ran slowly as expected on the board. However, whenever I clicked debug...