Loaded code "disappears" after a power cycle

I am using the MPC2300 with an LPC2368 NXP / Philips processor with uVision 3. The problem I am having is with file/image size. When loading anything lower than 64KB the program works and runs perfectly...
Loaded code "disappears" after a power cycle

I am using the MPC2300 with an LPC2368 NXP / Philips processor with uVision 3. The problem I am having is with file/image size. When loading anything lower than 64KB the program works and runs perfectly...
RTX task unresponsive. Power cycle doesn't help, but reset does.

Hi, All! I am dealing with the most obscure bug I have ever encountered. I am using LPC2144, Keil RTX and MDK 4.60. I have a task waiting for event (forever) that is triggered by a pin state transition...
RTX task unresponsive. Power cycle doesn't help, but reset does.

Hi, All! I am dealing with the most obscure bug I have ever encountered. I am using LPC2144, Keil RTX and MDK 4.60. I have a task waiting for event (forever) that is triggered by a pin state transition...
Getting Started Serial Interface on Phytec mm167 lost after power cycling.

I implemented the example on p.157 of the Getting Started manual on the Phytec mm167 board, along with corrections mentioned in the knowledge base. The example works well in debug mode, and I can flash...