C167 WDTCON reset indicator flags are not working

On reset recovery of the c167 controller i am reading wdtcon reset reason indication flags before EINIT instruction execution (Startup file). Flags are allways set to 0. due to this unable to identify...
C167 WDTCON reset indicator flags are not working

On reset recovery of the c167 controller i am reading wdtcon reset reason indication flags before EINIT instruction execution (Startup file). Flags are allways set to 0. due to this unable to identify...
/UART of C167 is not generated

Hello, I am trying to get an interrupt signal from C167 internal UART, which normally should be generated when there is a signal input at RX. I send out a command MVAR(), which generate TX output...
/UART of C167 is not generated

Hello, I am trying to get an interrupt signal from C167 internal UART, which normally should be generated when there is a signal input at RX. I send out a command MVAR(), which generate TX output...
Application did not start at 0x10000 on C167

hi, i hope i'm right here and someone can help me: I am using a C167CS with 2x 128k x8 flash (ST29F040BB) on the external 16 bit demultiplexed bus (with WRL&WRH). Flash is connected to CS0 (segment...