pll and clock setup issue on mcbstm32c

hey,, >>i want to use usart-2 peripheral on MCBSTM32C and i realised the baud rate set was incorrect, (inspite of right calculations) which was because of the incorrect plck-1 (=112.5Mhz, which should...
pll and clock setup issue on mcbstm32c

hey,, >>i want to use usart-2 peripheral on MCBSTM32C and i realised the baud rate set was incorrect, (inspite of right calculations) which was because of the incorrect plck-1 (=112.5Mhz, which should...
PLL,UART

I am new to keil,just give me some basic idea about initilizations involved.
PLL Configuration

Hi We are using LPC2366 controller When we configure the Internal RC oscillator(4 MHZ) for the PLL as shown below Main OScillator = disabled PLL source = Internal RC oscillator(4 MHZ ) ...
PLL ISSUE

Hi, I am working on ARM7 LPC2148 board. I want to know on which clock does the LPC2148 runs when I dont initialize PLL ? External oscillator of frequency 11.059 MHz is connected to the board. Could...