Port pins too slow

Hi.. I have a problem with the xc167ci. Its I/O-Pins toggle too slowly. If I have e.g. pin 4^0 toggeling, it only works with 2,85 MHz instead of 40 MHz (system clock). I use the following sourcecode...
Port pins too slow

Hi.. I have a problem with the xc167ci. Its I/O-Pins toggle too slowly. If I have e.g. pin 4^0 toggeling, it only works with 2,85 MHz instead of 40 MHz (system clock). I use the following sourcecode...
DebugIO over DCC too slow!

How to speed up debug output over DCC with ULink? Character rate is extremly low, aprox. 50 cps.
DebugIO over DCC too slow!

How to speed up debug output over DCC with ULink? Character rate is extremly low, aprox. 50 cps.
External Flash (via FSMC) too slow

Hello, I'm working with an STM32 (specifically the STM32F103ZE) with an external NAND Flash memory connected to it. I'm using the memory chip and schematic described in ST's application note AN2784...