About transferring 4-20mA to voltage

Dear friends, I am working on reading 4-20 mA from Level/pressure/flow transmitters. I used to use a 10 ohm resistor in series. so I measured the voltage drop on the resistor but in this circuit...
About transferring 4-20mA to voltage

Dear friends, I am working on reading 4-20 mA from Level/pressure/flow transmitters. I used to use a 10 ohm resistor in series. so I measured the voltage drop on the resistor but in this circuit...
PINs current

hi i m new to microcontrollers and i would like to know that when we make pins as output the IOH voltages are 5V and current is 60 microamp then how the high output can drive a 2SC1815 NPN Transitor...
PINs current

hi i m new to microcontrollers and i would like to know that when we make pins as output the IOH voltages are 5V and current is 60 microamp then how the high output can drive a 2SC1815 NPN Transitor...
Debug, Single step. Current source code line not highlighted

Hi @all Using the UV3/Arm7 I have a new problem. Placing a breakpoint in the C source code cause a break at that address but the Disassambly windows appears and the curent address position is...