show debug information

Hello, I want to install printf("hallo welt %d\n", intvariable) in my code for debug information. Where can I see this information when I have no usart? Is there a command line in uvision where I...
"insufficient debug information"

Hello everybody, I use the ULINK2 with the MCBSTM32 board. I use RTX Kernel too. I would like to use the RTX Kernel event viewer. I have configured the ITM Stimulus port and enabled the Trace with...
show debug information

Hello, I want to install printf("hallo welt %d\n", intvariable) in my code for debug information. Where can I see this information when I have no usart? Is there a command line in uvision where I...
"insufficient debug information"

Hello everybody, I use the ULINK2 with the MCBSTM32 board. I use RTX Kernel too. I would like to use the RTX Kernel event viewer. I have configured the ITM Stimulus port and enabled the Trace with...
Debug information with A51 and macros

Is anybody try to debug assembler code with MPL macros. In the source window, line in file is not correct adress instructions. I sent 2 email to Keil about three weeks and I haven't any answer. Also...