Ulink: connection RTCK and pull-ups

Hello, I use the Ulink2 jtag interface with the arm 20-pin connection. I have no possibility to use the RTCK Pin, so should I connect it with TDO, TCK or leave it unconnected? http://www.keil...
Ulink: connection RTCK and pull-ups

Hello, I use the Ulink2 jtag interface with the arm 20-pin connection. I have no possibility to use the RTCK Pin, so should I connect it with TDO, TCK or leave it unconnected? http://www.keil...
Ulink2 SW Clock Frequency

I'm using Keil Debugger SW adapter and wanting to run this at 10MHz clock rate. I set the Max Clock in the target debug setup to 10MHz, but when I run the debug session and monitor the SWCLK frequency...
Ulink2 SW Clock Frequency

I'm using Keil Debugger SW adapter and wanting to run this at 10MHz clock rate. I set the Max Clock in the target debug setup to 10MHz, but when I run the debug session and monitor the SWCLK frequency...
How to measure clock cycles with the uVision simulator?

Hello, I have a few questions about the uVision simulator for the Cortex-M4 floating-point instructions. 1. Does the uVision simulator model Cortex-M4 floating-point instructions cycle-accurately...